Ice maker water line hookup
Required Tools for this Project
Continue to 2 of 7 below. Coil the excess water line behind the refrigerator. Skip to main content. But do clamp the tubing to the fridge.
Turn the cold water on the supply line clockwise to close it. Then you back out the rod and water flows through a tiny hole into the tubing.
Drill holes in the base cabinet walls to route the water line from beneath the sink to the rear of the refrigerator. Attach the Adapt-a-Tee adapter to the shutoff valve, tightening by hand at first.
Step 1 — Locate and select the COLD water pipe in the floor hoyhoy reclame dating wall you will be using for the fridge water line. This usually will take an hour and a half or so to complete.
Tapping the Cold Water Line
If the refrigerator has a water dispenser, flush out ice maker water line hookup If you don't have a convenient water supply pipe and valve near the refrigerator, you must instead find another spot to hook up the water line. Once the water is clear, turn off the new water valve. Be prepared for a small amount Shut off the water at the valve that controls the cold-water supply pipe to the faucet.
A refrigerator with an automated ice maker and a built-in water dispenser does absolutely nothing if you do not have a water line to connect to it.
Place the end of the water line you intend to connect to the refrigerator into a 5-gallon bucket. Running a water line to a refrigerator to supply its ice maker and drinking water dispenser has never been easier. This will flush the gunk from the tube into the bucket. Set the ice maker to the "on" position as indicated in your specific model.