Refrigerator ice maker hookup How to Install an Icemaker

Refrigerator ice maker hookup

With all the work done on the back side of the freezer it's time to install the icemaker unit itself. Here is a step-by-step water line installation refrigerator guide.

Be sure to cut the end of the tubing square. Place the end of the water line you intend to connect to the refrigerator into a 5-gallon bucket. Information contained within RemoveandReplace. Avoid last-minute shopping trips by having all your materials ready ahead of time.

Plumb the fridge

Alternative connections These photos show alternative ways to connect to the cold water pipe. If you have a water dispenser on your fridge, dispense about a gallon of water and refrigerator ice maker hookup it down the kitchen sink drain. If you have a choice, select a vertical pipe not horizontal, as sediment can enter the fridge water line easier.

Step 2 — You will be drilling a hole into the cold water pipe so turn off the main water supply to your complete house.

St johns dating sites

If you have CPVC plastic or steel pipes, add tee fittings made of the same material. Run the Water Line The first step is to run the water line.

100 free dating american sites

Now turn on the faucet shutoff valve under the sink and check for leaks at the Adapt-a-Tee refrigerators ice maker hookup. To attach the tubing to the refrigerator, follow the owner's manual. Find your water supply lines beneath your sink. Adapt-a-Tees can be used in many situations where you need an extra line.

Install It

Slide the compression nut over the male threads and tighten it on the adapter. If there are no branch shutoff valves, you can turn off the water by closing the main water supply valve to the entire house. MORE pretty much anywhere there is an existing shutoff valve.

Pull it out a few inches Image 1.

Required Tools for this Project

Do not twist the nuts too tight as this could damage the supply valve, the supply line and the adapter. Turn off the supply line. If tightening the connection does not stop the leak, turn off the water, remove the connector and add additional thread-seal tape before reconnecting the water line.

Privacy Policy Sign Up. Once it's attached, open the new stop valve and check the entire piping system for leaks.

Speed dating auburn al

Installing a Water Line Is a Snap. MORE of water leakage as you remove the valve—this is just the standing water in the water pipe, and it can easily be sponged up. Mount the Unit to the Freezer Wall Mount the unit to the freezer wall by hanging the icemaker over the mounted screws; making sure to line up the extension tube into the reservoir.

Step 9 — Now the other end of your water tubing needs to be connected to the refrigerator. The first step is to run the water line. This article will show you how to run a water line to your refrigerator for an automatic ice maker and water dispenser. Drill as close to the back wall of the bobby dating website as possible, so you do not lose storage space inside the cabinet. Most contain a saddle valve which doesn't meet plumbing code in some regions and some contain refrigerator ice maker hookup tubing which can dry, split and leak over time.

To tap into the line, shut off the water to the house at the main. Attach the fill tube to the freezer by sliding the angled part of the tube into the inlet hole in the back of the freezer and screw it into place. Saddle valve for refrigerator water line.